Configuration Tools: Parameterization software for scanCONTROL
scanCONTROL Configuration Tools is a software to configure scanCONTROL sensors on a Windows PC. It helps you to set up the sensor, view profiles, save/load and export profiles.
In combination with scanCONTROL SMART sensors, the Configuration Tools software unfolds its true power. It parameterizes complex measuring tasks including all outputs via the corresponding interfaces. When used with COMPACT or HIGHSPEED sensors, the software simulates the algorithms even with loaded profiles.
All scanCONTROL sensors offer a lot of different options and settings. These settings are carried out using the scanCONTROL Configuration Tools software which e.g. provides direct access to the image of the sensor matrix in order to achieve an optimum basis setup. The live image of the matrix is used to optimize the alignment of the sensor in relation to the target.
One profile consists of up to 1280 calibrated measuring points depending on the sensor type. These profiles are transmitted via FireWire or Ethernet to the PC. scanCONTROL Configuration Tools provides the possibility to display or save these profiles in real-time. Especially for very fast processes it is an absolutely necessary feature, because it is also possible to load the profiles again and analyze the profiles step by step afterwards. For further analysis it is also possible to export the profiles into a format compatible with MS Excel.
The SMART series sensors are equipped with intelligent controllers for basic profile evaluations without additional hardware. The Configuration Tools software is designed for easy parameterization of SMART sensors. The idea is to divide a measuring task into separate measurements such as e.g. edge, angle, extrema, groove or seam. These separate measurements are combined to complex measuring tasks on the graphical user interface and evaluated. Therefore, the user benefits from a Plug&Play solution for individual tasks without requiring any programming skills.
Configuration tools offers 25 different basic programs to choose from which can be easily and quickly configured with only a few mouse clicks in the profile. The set parameters and results are immediately displayed on the screen. To measure an angle for example you simply choose two reference lines where the angle is calculated in between. Each measuring program also provides the possibility to cut out interesting sections in the profile. For dynamic measurement tasks also an individual dynamic tracking for each program is available and can easily be configured using an anchor point.
Once the individual measurement task parameters have been set up, the respective results are calculated together. This provides a simple method of calculating, for example, several angles or distances between points or lines against each other, or to project points onto lines. Without tedious external computations, measurement tasks can be solved that cannot be covered by one single measurement program. The sensor directly outputs the measured values in real time. Thus, there are no limits to the flexibility of calculating measurement values.
After all required programs have been configured, the software provides an overview of all measured results. The user decides how to transfer the results from the sensor, e.g. via Ethernet UDP, Modbus or as digital OK/NOK signal, stores these settings in a complete parameter set in the head of the SMART sensor and can then disconnect the sensor from the PC. The profiles are then analyzed directly on the sensor without PC.